Level 2 · Access Control
AC.L2-3.1.10
Session Lock
A session lock must stop access and hide previously visible information after the defined idle period.
Official reference
The requirement
Use session lock with pattern-hiding displays to prevent access and viewing of data after a period of inactivity.
DoD CMMC Assessment Guide, Level 2, version 2.13. AC.L2-3.1.10; requirement and objectives, printed page 36 ↗
Assessment objectives
What must be established
Determine if each applicable objective is satisfied. The labels below follow the cited DoD assessment guide.
- [a]
the period of inactivity after which the system initiates a session lock is defined;
- [b]
access to the system and viewing of data is prevented by initiating a session lock after the defined period of inactivity; and
- [c]
previously visible information is concealed via a pattern-hiding display after the defined period of inactivity.
MET requires evidence that all applicable objectives are satisfied. Final, approved evidence is needed. A NOT APPLICABLE determination needs a scope-based basis and is equivalent to MET for scoring. Enduring exceptions and temporary deficiencies have specific conditions under 32 CFR 170.24; they are not a general permission to defer implementation.
GAVII Cybersecurity assessment approach
Connect the objective to the evidence
Distinguish locking the display from terminating a session. Check workstations and other relevant user interfaces against the organization's specified inactivity period.
Assessment focus: objectives [a], [b], [c]. Use the methods together; a single example does not establish every objective.
Examine
Review the idle-time definition, applied configuration, and exceptions for representative endpoint types.
Interview
How do you know the idle-lock setting reaches devices that are temporarily disconnected from management?
Demonstrate or test
Use a safe test session to observe the idle lock and confirm that displayed content is obscured and access requires reauthentication.
Evidence gaps to look for
- A screensaver obscures content without locking.
- The configured time does not match the documented period.
GAVII Cybersecurity’s examples illustrate ways to examine, interview, and test. They are not a mandatory artifact list or a guarantee of an assessment result. Combine methods and address every applicable objective in the actual scope.
Assessment constraints
Scoring and POA&M eligibility
Score: 1
If this requirement is NOT MET, deduct 1 point from the Level 2 maximum of 110. The deduction applies to the requirement, not separately to each objective.
Scoring rule ↗POA&M: Eligible
Potentially eligible only if all Conditional Level 2 criteria are satisfied, including a score of at least 88 out of 110 and timely closeout. Eligibility is not a finding that this requirement is MET.
POA&M rule ↗Conditional Level 2 requires a score of at least 88 out of 110 and satisfaction of every eligibility condition. A 1-point requirement is not automatically eligible. The permitted POA&M must be closed through the appropriate closeout assessment within 180 days of the Conditional CMMC Status Date. An operational remediation plan does not confer Conditional Status.
Assessment planning
Location and observation
Not specifically listed in CAP P.11
This requirement is not specifically listed in CAP P.11. That does not establish that remote assessment is sufficient: the Lead CCA and C3PAO determine an adequate approach for the actual scope and evidence.
CAP §P.11, pages 10–11 ↗Check the source
References and related requirements
- DoD CMMC Assessment Guide, Level 2 ↗AC.L2-3.1.10; requirement and objectives, printed page 36. 2.13, September 2024.
- 32 CFR 170.24: Assessment findings and scoring ↗170.24(b) and (c)(2). Current electronic Code of Federal Regulations.
- 32 CFR 170.21: POA&M eligibility and closeout ↗170.21(a)(2) and (b). Current electronic Code of Federal Regulations.
- NIST SP 800-171 Rev. 2 ↗Requirement 3.1.10. February 2020, updated January 2021.
- NIST SP 800-171A ↗Assessment procedure 3.1.10. June 2018.
- Cyber AB CMMC Assessment Process (CAP) ↗P.11, printed pages 10-11; Level 2 certification assessment-location planning. 2.0, December 2024.
Program timing and contract applicability can change independently of these requirements. Check current DoD program notices and your solicitation or contract before making a compliance decision. Open the official DoD resource hub.